Evaluación de microcápsulas de ácido acetilsalicílico preparadas con eftalato de acetilcelulosa, etilcelulosa o sus mezclas, mediante una técnica de adición de emulsión no disolvente
Keywords:
Microencapsulación, Velocidad de liberación, Cinética de liberación, Microcápsulas en comprimidos, Técnica de adición no disolvente, Eftalato de acetato de celulosa, EtilcelulosaAbstract
El ácido acetilsalicílico (AAS) se encapsuló con eftalato de acetilcelulosa (EAC), etilcelulosa (EC) o sus mezclasmediante un método de adición de emulsión no disolvente. Se evaluaron los perfiles de liberación de AAS enmicrocápsulas preparadas en diversas proporciones de fármaco y polímero (10:1 y 4:1) y microcápsulas en comprimidosen un pH 1,2 ó 6. Los resultados mostraron que al reducir la proporción de fármaco respecto al polímero sereducía la velocidad de liberación. Las microcápsulas preparadas con EC presentaron el índice de liberación másbajo. Los estudios de liberación in vitro indicaron que la velocidad de liberación del fármaco disminuía tras lapreparación del comprimido, debido a la formación de una matriz no desintegrable. La liberación de AAS en un pH6 es significativamente mayor en todas las microcápsulas, incluso si se utiliza EC, que no es hidrosoluble. Esto sedebe probablemente a la mayor solubilidad del AAS en un pH 6, lo que indica la formación incompleta de la películaalrededor de las partículas de AAS. Los datos de liberación se examinaron cinéticamente y se calcularon los modelosideales para la liberación del fármaco. Los resultados mostraron que en las microcápsulas en comprimidos elcoeficiente de correlación más elevado se obtuvo con la liberación de orden cero. En las microcápsulas en comprimidosque contenían EAC o una mezcla de EAC y EC, la contribución de la erosión fue mayor que en las microcápsulasque no estaban en comprimidos.Downloads
References
Beyger J.W., Nairn J.G. (1986) Some factors affecting the microencapsulation of pharmaceuticals with cellulose acetate phthalate J. Pharm. Sci., 75: 573-578.
Deasy P.B. (1984) General introduction. Microencapsulation and related drug process, edited by Deasy, P.B., Marcel Dekker, New York, pp. 1-14.
Korsmeyer R.W., Gurney R., Doelker E., Buri P., Peppas N.A. (1983) Mechanisms of solute release from porous hydrophilic polymers. J. Pharm. Sci., 15: 25-35.
Lvasanifar A., Ghlandari R., Ataei Z., Zolfaghari M.E., Mortazavi S.A. (1997) Microencapsulation of theophylline using ethylcellulose: In vitro drug release and kinetic modeling J. Microencapsulation. 14: 91-100.
Merkel H.P., Speiser P. (1973) Preparation and in vitro evaluation of cellulose acetate phthalate J. Pharm. Sci., 62: 1444-1448.
Nixon J.R., Jalsenjak I., Nicolaodou C.F., Harris M. (1978) Release of drug from suspended and tableted microcapsules Drug Dev. Ind. Pharm., 16: 1829-1842.
Nixon J.R., Hassan M., (1980) The effect of tableting on the dissolution behaviour of thiabendazole microcapsules. J. Pharm. Pharmacol., 32: 857-859.
Nokhodchi A., Farid D. (1992) Effect of various factors on microencapsulation of acetyl salicylic acid by a non-solvent addition method. S.T.P. Pharma Sci., 2: 279-283. Nokhodchi A., Bolourtchian N.,
Farid D. (1999) Effects of hydrophilic excipients and compression pressure on physical properties and release behaviour of aspirin-tableted microcapsules. Drug Dev. Ind. Pharm., 6: 711-716.
Palomo M.E., Ballesteros M. P., Frutos P. (1996) Solvent and plasticizer influences on ethylcellulose-microcapsules. J. Microencapsulation., 13: 307-318.
Pongpaibul Y., Withworth C. W. (1986) Preparation and in vitro dissolution characteristics of propranolol microcapsules. Int. J. Pharm., 33: 243-248.
Pongpaibul Y., Withworth C.W. (1986) Microencapsulation by emulsion non-solvent addition method Drug Dev. Ind. Pharm., 12: 2387-2402.
Downloads
Published
How to Cite
Issue
Section
License
The articles, which are published in this journal, are subject to the following terms in relation to the rights of patrimonial or exploitation:
- The authors will keep their copyright and guarantee to the journal the right of first publication of their work, which will be distributed with a Creative Commons BY-NC-SA 4.0 license that allows third parties to reuse the work whenever its author, quote the original source and do not make commercial use of it.
b. The authors may adopt other non-exclusive licensing agreements for the distribution of the published version of the work (e.g., deposit it in an institutional telematic file or publish it in a monographic volume) provided that the original source of its publication is indicated.
c. Authors are allowed and advised to disseminate their work through the Internet (e.g. in institutional repositories or on their website) before and during the submission process, which can produce interesting exchanges and increase citations of the published work. (See The effect of open access).